GSO EN 1034-5:2011
Gulf Standard
Current Edition
·
Approved on
12 October 2011
·
Safety of machinery - Safety requirements for the design and construction of paper making and finishing machines - Part 5: Sheeters
GSO EN 1034-5:2011 Files
No files are available for this standard right now!
You can buy this standard from any member store
GSO EN 1034-5:2011 Scope
This European Standard applies to sheeters, including unwinding units, sheet stacker, drive and control units intended for use in paper making and shall be used together with !EN 1034-1:2000+A1:2009". Paper dust and edge strip suction devices are not covered by this standard. It deals with all significant hazards, hazardous situations and hazard events relevant to sheeters, when they are used as intended and under the conditions foreseen by the manufacturer (see clause 4). This standard does not apply to: - sheeters for corrugated board (see EN 1010-5); - sheeters for foil (see EN 1010-1); - sheeters with sheet feeders (see EN 1010-1); - guillotines (see EN 1010-3:2002). This document is not applicable to sheeters that have been manufactured before the date of publication of this document by CEN.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ASTM D4778:2024
ASTM D4778:15
Gulf Standard
Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions (Withdrawn 2024)
GSO ISO 21384-2:2024
ISO 21384-2:2021
Gulf Standard
Unmanned aircraft systems — Part 2: UAS components
GSO ISO 11114-6:2024
ISO 11114-6:2022
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 6: Oxygen pressure surge testing
GSO ISO 23598:2024
ISO 23598:2021
Gulf Standard
Mechanical joining of sheet materials — Destructive testing of joints — Specimen dimensions and procedure for mechanized peel testing of single joints